Statics Design Project

Statics Design Project Third Design Project University of Wisconsin - capital of Wisconsin Abstract For this formula project I was required to design a shaft for a water turbine that must stop power to an electric generator and also to a lay elevator for carrying grain to a hopper while brush the criteria given to me by my boss. I was given some sign values and am supposed to place two bearings B and D to support the shaft to meet the criteria given. Design Criteria Shown down the stairs is the diagram I was given to find the placement of bearings B and D.

I was given that the total bending load on the shaft at the sprocket C is 815 lb, and the driven status of the chain is oriented at an angle of 40 deg from the vertical. At gear E, Which drives the generator, the bending forces on the shaft are 494lb in the y-direction, and 180lb in the x-direction. Also the flat whang pulley A which drives the elevator, the maximum allowable tension in the belt is 417lb. The belt will be par...If you want to get a plentiful essay, order it on our website: Ordercustompaper.com

If you want to get a full essay, wisit our page: write my paper